Monessen 30 Inch Multi-Sided Designer See-Thru Vent Free Propane Gas Log Set - Millivolt On/Off Remote Ready - $756.66

Vent Free Gas Logs:
Vent Free (also known as non-vented, unvented or ventless)Gas Logs do not require a chimney. They keep 99 percent of the heat produced in your home, and are very efficient as a primary heat source. All of our vent free logs are equipped with an ODS (Oxygen Depletion Sensor). This device cuts the flame off if the oxygen level in the air drops below a safe level. (This situation is very rare) Vent Free logs cannot be repositioned once they are installed. This is due to vent free log sets having to maintain a complete clean burn which requires the logs to sit on the grate in only one way. Some states (California, Massachusetts, and a few others) require special permits in order to operate non-vented appliances indoors. It is the customer's responsibility to know his or her local codes and limitations.
Compare "Vent Free" to "Vented"

See-Thru Logs:
See-Thru Gas Log sets are for fireplaces that have openings on both sides (like a fireplace that has an opening facing your den and one facing your dining room). You can also place "See-Thru" gas log sets in peninsula fireplaces (openings on 3 sides). "See-Thru" log sets are "finished" on all sides so they look very nice from any angle. Standard gas log sets are only "finished" on the front side.
Compare "See-Thru" Logs to "Standard"

Designer Log:
DST Designer Log Fiber Ceramic features a multisided yellow flame log design for use with a See-Thru, Peninsula and Corner firebox.
Compare Monessen Vent Free Gas Logs

Monessen Control Systems

Monessen ANSI certified gas log sets are avalable with 3 possible safety pilot kits:

Manual Safety Pilot
Millivolt On/Off Remote Ready (no remote included)
Hi/Lo Variable Flame Remote Ready (no remote included)

Monessen offers a variety of control devices to be added on to any of the remote ready pilot kits. You can match up any control that says Millivolt On/Off in the item name with any pilot kit or log set that says Millivolt On/Off in its item name. The same is true for Hi/Lo Variable Flame. You can not however mix them up. For example, you can not add a Millivolt On/Off remote control to a Hi/Lo Variable Flame remote ready pilot kit or log set or vice versa.

Click here to see a full color catalog of the Ambient Technologies control options.